If your program says “isometric squat, 4 × 10 seconds”, I still don’t know what you want the athlete to do. Are they holding a loaded bar at a fixed depth, or trying to drive a bar through the upper pins? Write that into the prescription.
The distinction between yielding and overcoming isometrics is the task you give the athlete. A loaded hold and a push against fixed resistance need different instructions, even when neither produces visible movement.
Yielding isometrics: hold the load
With a yielding isometric, the external load sets the demand. The athlete produces enough force to maintain the position. In a loaded squat hold, choose a depth and keep the bar clear of the safeties for the full set.
I’d start with 3 × 15 seconds, with 90 seconds’ rest, using a load the athlete can hold at the same depth from the first second to the last. If they sink or change their position to make the hold easier, end the set. Add load once they can repeat that position across all three sets.
The cue is to hold the chosen position against the load. The time written in the program only counts if that position is maintained.
Overcoming isometrics: drive into the pins
With an overcoming isometric, the athlete pushes or pulls against something fixed. For the squat example, set the upper pins at the position you want to train, take up the slack, then drive into them.
For a high-force squat effort, a starting prescription is 4 × 4 seconds, with 2 minutes’ rest. If the objective is rapid force production, cue the athlete to build force quickly once they have established tension. A maximal effort and a fast onset are two different instructions; specify which one you want.
Two coaching examples
| Method | Squat task | Starting prescription | Athlete cue |
|---|---|---|---|
| Yielding | Hold a loaded bar at a chosen depth, clear of the safeties | 3 × 15 seconds; 90 seconds’ rest | Keep the same depth throughout |
| Overcoming | Push the bar against fixed upper pins at the chosen position | 4 × 4 seconds; 2 minutes’ rest | Take up the slack, then drive hard; build force quickly when that is the objective |
These are coaching examples. The different durations above do not define the two methods: both can be prescribed at the same intensity and duration.
What the cited study tested
In a six-week knee-extension study, Lum and colleagues (2026) studied 10 adults, with one leg assigned to pushing and the other to holding. Across 12 sessions, both conditions used 20-second efforts at 70% of maximal voluntary contraction, at an 80° knee angle, for 4–6 repetitions. Both improved isometric torque and increased quadriceps muscle thickness. Read the study abstract.
That was a small knee-extension study. It does not establish the squat examples above as tested protocols or show that one method is universally better. The practical point is that pushing and holding can both train isometric strength, and the task, effort and duration all need to be prescribed.
Write the whole prescription
When you put an isometric into a meso, specify the joint position, load or effort, duration, rest and athlete cue. If the job is to sustain a position against a known load, give the athlete a hold. If the job is to drive hard at a particular position, give them fixed resistance to push against.
The exercise name and a number of seconds leave too much unanswered. Write what the athlete must do, what counts as a successful effort and when the set ends.
Reference: Lum D, Oranchuk DJ, Chen SE, Kong PW. Comparing the Effects of Push and Hold Isometric Training on Strength and Musculotendinous Adaptations: A Within-Subject Randomized Controlled Trial. Journal of Strength and Conditioning Research. 2026;40(9):1050–1058. doi:10.1519/JSC.0000000000005475. Research details above were checked against the abstract.
Adapted from my yielding versus overcoming isometrics carousel, published 21 November 2026 in Australia.




