For an experienced lifter, I’d use 10 sets of three on the back squat in the A series of a maximal-strength meso. Use a 40X0 tempo, rest four minutes between sets, and step load across the ten work sets with a 10–15% spread from the first set to the last.
Ten separate exposures to the squat
I use the high number of sets to saturate the motor pattern. You get 30 reps across ten separate exposures to the squat, with each set giving the lifter another chance to set up and produce force in the same movement. Three reps per set lets me get that amount of work in without asking for long sets.
The 40X0 prescription means a four-second eccentric, no pause at the bottom, an intent to lift explosively on the concentric, and no pause at the top. Keep that prescription consistent as the weight increases.
A worked loading example
| Work sets | Load | Reps per set |
|---|---|---|
| 1–2 | 135 kg | 3 |
| 3–4 | 140 kg | 3 |
| 5–6 | 145 kg | 3 |
| 7–8 | 147.5 kg | 3 |
| 9 | 150 kg | 3 |
| 10 | 152.5 kg | 3 |
That is a 17.5 kg increase from the first work set to the last, or approximately 13%. The 10–15% spread describes the increase across the work sets; it is not a percentage of 1RM. With ten sets to work through, I can repeat loads early and make the jumps smaller towards the end.
Work backwards from set ten
I work backwards from what I expect the lifter to triple on set ten at 40X0. That is their triple after nine sets. Choose the earlier loads with that final set in mind.
If set seven is already close to a 3RM, the starting weight was too high or the load went up too quickly. I’d stop increasing it there and reduce it if needed to finish the remaining triples. At the next session, I’d adjust the earlier sets.
Progress the loading steps
If the lifter gets all ten triples at the prescribed tempo and still has room on the last set, I’d move the loading steps up slightly at the next exposure. Completing the reps, keeping the tempo and assessing the final set all inform that decision.




