Klokov back squat protocol: seven singles at 76X0 with four minutes of rest between sets.

ARTICLE

Klokov Squat Protocol: Seven Singles at 76X0

The Klokov squat protocol is 7 sets of 1 barbell back squat at 76X0, with 4 minutes of rest between sets. I’d use it with an experienced lifter who needs better control on the descent or more practice driving out of a dead stop at depth.

How to squat at 76X0

7: Lower for seven seconds. Spread the count across the whole descent and reach your usual squat depth on the seventh second.

6: Hold at depth for six full seconds. Start the count when the bar stops descending. Keep your brace and maintain pressure through your feet throughout the hold.

X: Drive up with maximal intent. Try to accelerate as you stand, even if the bar moves slowly.

0: Finish the rep and rack the bar without a prescribed pause at the top. Rest four minutes before the next set.

Each repetition includes a 13-second controlled descent and pause before returning to the starting position. Across seven sets, that’s 49 seconds of lowering and 42 seconds at depth.

Choose the load after a full-tempo warm-up single

Warm up as usual, then rehearse the whole rep before you pick your working weight. Have someone call the counts or use an audible timer. Time the descent and the hold separately. On the first exposure, choose a weight that gives you a clean seventh single at the same depth and tempo as the first.

Watch the last third of the descent. If you spend most of the seven seconds getting partway down and then drop into the bottom, spread the count more evenly. If you cut the hold short, lose your brace or shift position to get the bar moving, take weight off for the remaining sets.

Track the singles that meet the prescription

If you’re unsure about depth or timing, film a single from the side. Check that the bar has stopped descending before you start counting the hold. Compare your first and last singles and record how many met the standard. If six out of seven did, keep the load where it is for the next exposure. Once all seven meet the same depth, tempo and rest prescription, make a small load increase the next time you run it.

Where I’d place it in a meso

Put it first in the session and use the stance and depth you’re trying to improve. Pick it when you need the lifter to control the descent or drive out of a dead stop at that depth. Those are the standards you’ll use to judge the set and decide when to add weight.

I teach how to prescribe tempo and place strength work within a meso at Essentials of Advanced Program Design, 5–6 December 2026 in Melbourne, Victoria.

See the original Instagram post.

Dale Hansford

WRITTEN BY

Dale Hansford

Strength & Conditioning Coach with 15+ years of applied experience. Specialising in program design, periodisation, and coaching education for serious coaches and athletes.

Learn more about Dale →

TAKE THE NEXT STEP

Want to Master Program Design?

Learn how to write systematic, evidence-based training programs that produce real results. Explore the mentorship, self-paced courses, or free resources.

KEEP READING

Related Articles