Coach Dale's isometronics protocol: close-grip bench press between two pairs of rack pins, 4–6 partial reps, final push for 6–8 seconds, three sets per range and three minutes rest.

ARTICLE

Isometronics for Maximal Strength: Close-Grip Bench Press

If a lifter consistently stalls at the same point in the bench press, I want to train their ability to produce force in that part of the lift. With isometronics, you press through a short range and finish the last rep by driving the bar into the upper pins. The bar stops moving, but the effort continues.

Set up two pairs of pins

Set up the bench inside a power rack with two pairs of pins. The lower pins catch the bar at the bottom of the partial; the upper pins stop it at the top. Check both heights with an empty bar and use a spotter.

Divide the close-grip bench press into thirds. Start with the lower range, then move to the middle and upper ranges. Move both pairs of pins when you change ranges so that the bar travels through the part of the press you want to train.

The isometronics protocol

  • Perform 3 sets in each range: lower, middle and upper.
  • Complete 4–6 heavy partial reps per set.
  • On the last rep, press hard into the upper pins for 6–8 seconds.
  • Rest 3 minutes between sets.

That gives you nine sets across the three ranges. The final push is part of the last rep of each set. Keep pressing hard into the pins for the prescribed 6–8 seconds, keep breathing, then lower the bar to the bottom safeties.

Choose the load for each range

Choose the load separately for each range. If the lifter can handle more weight near lockout, use a load that suits that range. The lower, middle and upper positions do not have to use the same weight.

The pin heights define the range being trained, so I’d log them alongside the weight and reps for each position. That gives me a record of what the lifter actually did, rather than just a weight written against “bench press”.

Check the full-range press

When I go back to the full-range bench press, I want to see whether the lifter can get through the point that was stopping the press. That is the coaching question behind using this protocol.

Original isometronics close-grip bench-press post on Instagram

Dale Hansford

WRITTEN BY

Dale Hansford

Strength & Conditioning Coach with 15+ years of applied experience. Specialising in program design, periodisation, and coaching education for serious coaches and athletes.

Learn more about Dale →

TAKE THE NEXT STEP

Want to Master Program Design?

Learn how to write systematic, evidence-based training programs that produce real results. Explore the mentorship, self-paced courses, or free resources.

KEEP READING

Related Articles